請用此 Handle URI 來引用此文件:
http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/19023
標題: | 以CMOS製程之接收信號強度指示電路設計 Design of Received Signal Strength Indicator Circuit in CMOS Process |
作者: | Chao-Wei Huang 黃朝偉 |
指導教授: | 盧信嘉(Hsin-Chia Lu) |
關鍵字: | 接受信號強度電路,連續檢測對數放大器,限制放大器,非對稱源極耦合差動對, received signal strength indicator circuit,successive detection logarithmic amplifier,limiting amplifier,unbalanced source-coupled differential pairs, |
出版年 : | 2016 |
學位: | 碩士 |
摘要: | 此論文研究使用連續檢測對數放大器架構設計接收信號強度指示電路,使用製程為TSMC 0.18μm CMOS製程和TSMC 40nm CMOS製程。其中連續檢測對數放大器架構是由限制放大器、非對稱源極耦合差動對和低通濾波器組成。在0.18μm CMOS製程下量測結果在0.1GHz到1GHz之間約有38dB的動態範圍,在1GHz到2GHz之間約有30dB的動態範圍功率,消耗為22.45mW,晶片面積為0.28 。在40nm CMOS製程下模擬結果在0.1GHz到2.5GHz之間約有40dB的動態範圍,功率消耗為7.66mW,晶片面積為0.06 mm2。 This thesis designs received signal strength indicator circuits (RSSI) by using successive detection logarithmic amplifier (SDLA) topology under TSMC 0.18μm and 40nm CMOS technology. Successive detection logarithmic amplifier composes of limiting amplifier, unbalanced source-coupled differential pair and low-pass filter. In design using 0.18μm CMOS process, the measurement results show that dynamic range of about 38dB from 0.1GHz to 1GHz, and dynamic range of 30dB from 1GHz to 2GHz. DC power consumption is 22.45mW, and chip size is 0.28 . In 40-nm CMOS process, the stimulation results show dynamic range with 40dB from 0.1GHz to 2.5GHz, and DC power consumption is 7.66mW with chip size of 0.06 mm2. |
URI: | http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/19023 |
DOI: | 10.6342/NTU201603005 |
全文授權: | 未授權 |
顯示於系所單位: | 電子工程學研究所 |
文件中的檔案:
檔案 | 大小 | 格式 | |
---|---|---|---|
ntu-105-1.pdf 目前未授權公開取用 | 6.01 MB | Adobe PDF |
系統中的文件,除了特別指名其著作權條款之外,均受到著作權保護,並且保留所有的權利。