請用此 Handle URI 來引用此文件:
http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/30980
標題: | 片狀氧化鋁及稜角狀莫來石於氧化鋁基材上生成機制之研究 Study on the Formation mechanism of Tabular Al2O3 and Prismatic Mullite Formation on Alumina Substrate |
作者: | Bang-Ying Yu 虞邦英 |
指導教授: | 韋文誠 |
關鍵字: | 氧化鋁,片狀,莫來石,稜角狀,氧化鋁基材,生長機制, alumina,tabular,mullite,prismatic,alumina substrate,formation mechanism, |
出版年 : | 2007 |
學位: | 博士 |
摘要: | 本研究使用氧化鋁-氧化矽雙相溶膠(diphasic aluminum silicate sol)在多孔及緻密氧化鋁基材上,以低於共晶溫度(1560oC)的熱處理條件(1280oC)形成鍍膜。在多孔氧化鋁基材上,生成片狀(tabular)氧化鋁的互鎖(interlock)結構;而在緻密96%純度氧化鋁基材上,則生成針狀(acicular)莫來石的互鎖結構。
實驗中以矽酸四乙酯(TEOS,tetraethlylorthosilicate)和氫氧化鋁(boehmite)分別當作鋁、矽原子的來源,形成氧化鋁-氧化矽雙相溶膠。在固定鋁矽莫耳比為莫來石當量比3Al2O3•2SiO2的條件下,利用旋轉塗佈法(spin coating)在氧化鋁基材上生成雙相氧化鋁-氧化矽(簡稱DAS)薄膜,經過乾燥和1280oC熱處理得到具有非等向晶粒鍍膜的高溫陶瓷複合材料。所得到的複合材料經由X光繞射儀(XRD)、掃描式電子顯微鏡暨能量分析光譜儀(SEM&EDX)、與分析式穿透電子顯微鏡(AEM)及電子能量損失譜儀(EELS)來進行成分及微結構的觀察。研究中採用不同的純度、鍍膜成分或熱處理條件等製程參數,並製備多種條件的多孔陶瓷TEM樣品,針對非等向晶粒在氧化鋁基材上生成的機制進行探討。 DAS鍍膜在多孔氧化鋁基材上會形成以片狀氧化鋁為主的層狀結構。在薄膜中,片狀晶交錯生成,產生微米級的孔洞,一片狀氧化鋁晶粒中含有數個方向相同的次片狀晶(sub-tabular grain),片狀晶的最大平面為(000h)AlO。同一個片狀晶中的次片狀晶晶粒生長方向略有不同,但不論成分鑑定或晶相分析皆能証明其為氧化鋁。 在96%緻密氧化鋁基材上的DAS薄膜經燒結後會生成針狀莫來石。經過TEM的晶相分析,針狀莫來石具有的軸向(zone direction)為[001]M,長度為5-20 In this study, diphasic aluminum silicate sol (M) was coating on porous or dense alumina substrate to form a covering layer (DAS) and then sintered at 1280oC, which was below eutectic temperature (1560oC) of Al2O3-SiO system. A gradient, porous Al2O3 substrate was prepared with the characteristics of micro-sized tabular grains on surface, fine interlocking of Al2O3 grains in matrix. Acicular mullite grains were formed on dense Al2O3 substrate with interlocking structure. The sample was made by spin-coating alumina substrates with diphasic gel made by pseudo-boehmite (AlOOH) and hydrolyzed TEOS [Si(OC2H5)4]. After drying and sintering at different heat treatments, which at the temperature 1280oC, the crystallography and microstructure of the porous structure was investigated by analytical electron microscopy (AEM), X-ray differactometry (XRD), and scanning electron microscopy (SEM). Detailed micro-beam compositional and structural analyses were conducted in order to verify the glassy phase and abnormal Al2O3/ mullite grains. The abnormal grain growth of Al2O3 grains is possibly due to the transient SiO2-glass phase during sintering above 1250oC. The formation of tabular grains is due to a heterogeneous nucleation from faceted grain of Al2O3/Glass interface, ripening from transient Al2O3 nano-crystals through amorphous SiO2 glass. The reactions are limited to regions where the density is higher, and results in a perpendicular growth of plate-like grains on the substrate. Ostwald ripening in association with the rearrangement of small transient |
URI: | http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/30980 |
全文授權: | 有償授權 |
顯示於系所單位: | 材料科學與工程學系 |
文件中的檔案:
檔案 | 大小 | 格式 | |
---|---|---|---|
ntu-96-1.pdf 目前未授權公開取用 | 20.99 MB | Adobe PDF |
系統中的文件,除了特別指名其著作權條款之外,均受到著作權保護,並且保留所有的權利。