請用此 Handle URI 來引用此文件:
http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/64204
標題: | 單晶矽與石英之蝕刻速率研究 Study of Etching Rate for Single Crystal Silicon and Quartz |
作者: | Keng-Wei Chang 張耕瑋 |
指導教授: | 張家歐 |
關鍵字: | Z-cut石英,單晶矽(110),蝕刻速率,米勒指標,二維蝕刻理論, z-cut quartz,single crystal silicon,etch rate,miller indices,two dimensional etch theory, |
出版年 : | 2012 |
學位: | 碩士 |
摘要: | 本文之主要目的為利用微機電製程,在矽(110)晶圓和Z-cut石英晶圓上製造出ㄇ字型之蝕刻圖案,並以30%及40%重量百分濃度之KOH溶液蝕刻矽晶圓,以重量百分濃度49.5%之氫氟酸溶液和40%之氟化氨溶液以2:3比例調配之蝕刻液蝕刻石英晶圓,蝕刻溫度都控制在80℃,蝕刻時間為60分鐘,再利用晶圓切割機切開蝕刻斷面,觀察量測蝕刻面之形狀以及角度,來驗證張簡文添提出之二維蝕刻理論,並計算出各蝕刻面之米勒指標以及蝕刻速率。 The purpose of this thesis is to study the etching behavior of single crystal silicon (110) and quartz (z-cut). By using micro-electronic mechanical system frabrication, we can create specific pattern on the wafer surface. According to the two dimensional etch theory, we can decide the miller indices and calculate the etch rate of any lattice plane by measuring the geometric change of the pattern. We can verify the two dimensional etch theory and establish a data sheet for the futhre work. |
URI: | http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/64204 |
全文授權: | 有償授權 |
顯示於系所單位: | 應用力學研究所 |
文件中的檔案:
檔案 | 大小 | 格式 | |
---|---|---|---|
ntu-101-1.pdf 目前未授權公開取用 | 7.84 MB | Adobe PDF |
系統中的文件,除了特別指名其著作權條款之外,均受到著作權保護,並且保留所有的權利。