請用此 Handle URI 來引用此文件:
http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/30821
完整後設資料紀錄
DC 欄位 | 值 | 語言 |
---|---|---|
dc.contributor.advisor | 胡文聰(Andrew M. Wo) | |
dc.contributor.author | Jah-Ming Lai | en |
dc.contributor.author | 賴志銘 | zh_TW |
dc.date.accessioned | 2021-06-13T02:16:59Z | - |
dc.date.available | 2007-02-27 | |
dc.date.copyright | 2007-02-27 | |
dc.date.issued | 2007 | |
dc.date.submitted | 2007-02-09 | |
dc.identifier.citation | 1. Huang, Y., et al., Dielectrophoretic cell separation and gene expression profiling on microelectronic chip arrays. Analytical Chemistry, 2002. 74(14): p. 3362-3371.
2. Gascoyne, P.R.C., et al., Dielectrophoresis-based programmable fluidic processors. Lab on a Chip, 2004. 4(4): p. 299-309. 3. Pohl, H.A. and I. Hawk, Separation of Living and Dead Cells by Dielectrophoresis. Science, 1966. 152(3722): p. 647-&. 4. Yang, J., et al., Dielectric properties of human leukocyte subpopulations determined by electrorotation as a cell separation criterion. Biophysical Journal, 1999. 76(6): p. 3307-3314. 5. Li, H.B. and R. Bashir, Dielectrophoretic separation and manipulation of live and heat-treated cells of Listeria on microfabricated devices with interdigitated electrodes. Sensors and Actuators B-Chemical, 2002. 86(2-3): p. 215-221. 6. Gascoyne, P.R.C. and J. Vykoukal, Particle separation by dielectrophoresis. Electrophoresis, 2002. 23(13): p. 1973-1983. 7. Gascoyne, P.R.C. and J.V. Vykoukal, Dielectrophoresis-based sample handling in general-purpose programmable diagnostic instruments. Proceedsings of the Ieee, 2004. 92(1): p. 22-42. 8. Rousselet, J., G.H. Markx, and R. Pethig, Separation of erythrocytes and latex beads by dielectrophoretic levitation and hyperlayer field-flow fractionation. Colloids and Surfaces a-Physicochemical and Engineering Aspects, 1998. 140(1-3): p. 209-216. 9. Wang, X.B., et al., Cell separation by dielectrophoretic field-flow-fractionation. Analytical Chemistry, 2000. 72(4): p. 832-839. 10. Pethig, R., M.S. Talary, and R.S. Lee, Enhancing traveling-wave dielectrophoresis with signal superposition. Ieee Engineering in Medicine and Biology Magazine, 2003. 22(6): p. 43-50. 11. Gascoyne, P., et al., Microsample preparation by dielectrophoresis: isolation of malaria. Lab on a Chip, 2002. 2(2): p. 70-75. 12. Schnelle, T., et al., Paired microelectrode system: dielectrophoretic particle sorting and force calibration. Journal of Electrostatics, 1999. 47(3): p. 121-132. 13. Choi, S. and J.K. Park, Microfluidic system for dielectrophoretic separation based on a trapezoidal electrode array. Lab on a Chip, 2005. 5(10): p. 1161-1167. 14. Park, J., et al., An efficient cell separation system using 3D-asymmetric microelectrodes. Lab on a Chip, 2005. 5(11): p. 1264-1270. 15. Chen, D.F., H. Du, and W.H. Li, A 3D paired microelectrode array for accumulation and separation of microparticles. Journal of Micromechanics and Microengineering, 2006. 16(7): p. 1162-1169. 16. K.Cheng, D., Field and Wave Electromagnetics. Addison Wesley ed. 1989. 17. Green, N.G., A. Ramos, and H. Morgan, Numerical solution of the dielectrophoretic and travelling wave forces for interdigitated electrode arrays using the finite element method. Journal of Electrostatics, 2002. 56(2): p. 235-254. 18. Griffiths, D.J., Introduction to Electrodynamics. Prentice Hall ed. 1999. 19. Jones, T.B., Electromechanics of Particles. Cambridge University Press ed. 1995. 20. Jones, T.B., Basic theory of dielectrophoresis and electrorotation. Ieee Engineering in Medicine and Biology Magazine, 2003. 22(6): p. 33-42. 21. Lee, U., Introduction of Fluid Mechanics. Institute of Applied Mechanics, National Taiwan University ed. 2001. 22. White, F.M., Viscous Fluid Flow. McGRAW-HiLL International ed. 1991. 23. Molla, S.H. and S. Bhattacharjee, Prevention of colloidal membrane fouling employing dielectrophoretic forces on a parallel electrode array. Journal of Membrane Science, 2005. 255(1-2): p. 187-199. | |
dc.identifier.uri | http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/30821 | - |
dc.description.abstract | 本研究主要利用介電泳原理在微流體裝置下以分離同性質之不同大小群體微粒子,並計算分析此一分離過程。此一過程是藉著設計不同電極的形狀,包括有層狀電極、梯狀電極、雷狀電極三種形狀,以產生異質非均勻電場的效應。在本研究中,通過電場的粒子大小選定為5微米、10微米、15微米和20微米,並藉由負介電泳作用力(粒子遠離電場較強的方向)和史托克力(流體的阻力)的相互作用,使得粒子通過電場。這種負介電泳作用力是由Clausius-Mossotti (CM) 因子的參數對應頻率範圍所選定。因此,分離的結果是經由負介電泳作用力和史托克力(流體的阻力)的總和所推導出的粒子軌跡方程式而計算出的。並分析分離因子(負介電泳作用力和史托克力的比值)與分離結果的關係,來探討粒子作用力的平衡和在三種不同形狀電極下的分離狀態。
經由本研究的計算,當頻率大於600赫茲時,不同大小的粒子可於層狀電極和梯狀電極中依據其尺寸被分離。整體而言,本研究所採用的分離因子與分離的效果有極為密切的關係。根據分離因子的分析,發現當電極的交流輸入訊號增加時,可分離粒子之流速也會隨之增加且流速範圍加大,這是本研究極為重要的考量之一。而在雷狀電極的設計及計算結果的分析中,當粒子大小同時包括有10微米、15微米、20微米時,其分離結果良好。且當粒子大小同時有5微米和10微米時亦然。然而,當粒子大小同時包括有5微米、10微米、15微米和20微米時,則其分離的結果不佳。 | zh_TW |
dc.description.abstract | This thesis presents the computation of separation of size-specific particles using dielectrophoresis (DEP) in a microfluidic device. The goal of the study is to separate heterogeneous population of particles into bins downstream. Different configurations of electrodes are designed, such as gradual, step, and deterministic, in order to achieve non-uniform electric field strength. Particles of diameters 5μm, 10μm, 15μm, and 20μm are used. Parameters of the Clausius-Mossotti (CM) factor were determined to achieve negative dielectrophoresis (nDEP) at the range of specified frequencies. The relations between negative dielectrophoretic force (nDEP) and drag force are used to derive the governing equation of particle trajectories. An overarching parameter, called sorting factor, was derived to account for the force balance on the particle and it also serves to compare performance among the three electrode designs.
Results of computation showed that size-specific particles could be separated at the frequency above 600Hz by using gradual and step electrode designs. As a whole, the sorting factor serves well to correlate the efficacy of separation in most cases studies. According to sorting factor analysis, if the input A.C. signals increases, the range of the flow velocity also increases which is an important consideration for this device. Furthermore, the suitable input A.C. signals are chosen for this experiment. However, the deterministic electrodes of these devices may separate particles of 10μm, 15μm, and 20μm in diameters and particles of 5μm and 10μm in diameters. For the moment of the result of computation, the deterministic electrode of this device may not completely separate size-specific bioparticles. | en |
dc.description.provenance | Made available in DSpace on 2021-06-13T02:16:59Z (GMT). No. of bitstreams: 1 ntu-96-R93543022-1.pdf: 3252036 bytes, checksum: cccf6dfedb9e975b8771e89a3e24c29e (MD5) Previous issue date: 2007 | en |
dc.description.tableofcontents | 致謝 I
ABSTRACT II 中文摘要 III List of Figures VI List of Tables XIII List of Symbols XIV Chapter 1 Introduction and Literature Review 1 1.1 Introduction 1 1.2 Literature Review 2 1.3 Motivation of This Thesis 3 Chapter 2 Theory 4 2.1 Dielectrophoretic force 4 2.1.1 Electrostatic Theory 4 2.1.2 Dipole Approximation 5 2.1.3 Polarization of Particles 6 2.1.4 Derivation of Dielectrophoresis Force 9 2.1.5 Clausius-Mossotti Factor 10 2.2 Drag Force 11 2.3 Governing Equation of Force on a Particle 12 2.4 Sorting Factor 12 Chapter 3 Numerical Method 14 3.1 Simulation Tools 14 3.2 Numerical Method 14 3.2.1 Boundary Value Problem 14 3.2.1.1 Electric Field Issues 14 3.2.1.2 Fluid Issues 16 3.2.2 Initial Value Problem 16 3.3 Verification 18 Chapter 4 Results and Discussions 20 4.1 Calculation of CM factor 20 4.2 Analysis of Flow and Electric Field with Top and Bottom Electrodes 20 4.2.1 Two-Dimensional Flow Analysis 20 4.2.2 Electric Field and DEP Force Analysis 21 4.2.3 Trajectory Analysis 22 4.3 Various Designs of Electrodes 22 4.3.1 Three-Dimensional Flow Analysis 22 4.3.2 Boundary Condition of Electric Field Issues 23 4.3.3 Flow in Concentration Region 24 4.3.4 Gradual Electrode Device Analysis 25 4.3.4.1 Gradual Electrode Design 26 4.3.4.2 Sorting Factor Analysis of Gradual Electrode 28 4.3.4.3 Discussions of Gradual Electrode Designs 29 4.3.5 Step Electrode Device Analysis 29 4.3.5.1 Step Electrode Design 1 30 4.3.5.2 Sorting Factor Analysis of Step Electrode 1 31 4.3.5.3 Step Electrode Design 2 32 4.3.5.4 Sorting Factor Analysis of Step Electrode 2 34 4.3.5.5 Discussions of Step Electrode Designs 34 4.3.6 Compare Gradual Electrode with Step Electrode 35 4.3.7 Deterministic Electrode Device Analysis 35 4.3.7.1 Deterministic Electrode Design 1 35 4.3.7.2 Deterministic Electrode Design 2 36 4.3.7.3 Deterministic Electrode Design 3 37 4.3.7.4 Discussions of Deterministic Electrode Designs 38 Chapter 5 Conclusions and Future Work 39 5.1 Conclusions 39 5.2 Future Work 40 Reference 41 Appendix 43 Figures and Tables 47 | |
dc.language.iso | en | |
dc.title | 使用介電泳分離微粒子之計算探討 | zh_TW |
dc.title | Computational Study of Separation of Size-Specific Microparticles Using Dielectrophoresis | en |
dc.type | Thesis | |
dc.date.schoolyear | 95-1 | |
dc.description.degree | 碩士 | |
dc.contributor.oralexamcommittee | 李雨(U. Lei),朱錦洲(Chin-Chou Chu),鍾孟軒(Meng-Suan Zhong) | |
dc.subject.keyword | 介電泳,分離,史托克力,分離因子,微流體。, | zh_TW |
dc.subject.keyword | Dielectrophoresis,Sepatation,Drag force,Sorting factor,microfluid, | en |
dc.relation.page | 129 | |
dc.rights.note | 有償授權 | |
dc.date.accepted | 2007-02-09 | |
dc.contributor.author-college | 工學院 | zh_TW |
dc.contributor.author-dept | 應用力學研究所 | zh_TW |
顯示於系所單位: | 應用力學研究所 |
文件中的檔案:
檔案 | 大小 | 格式 | |
---|---|---|---|
ntu-96-1.pdf 目前未授權公開取用 | 3.18 MB | Adobe PDF |
系統中的文件,除了特別指名其著作權條款之外,均受到著作權保護,並且保留所有的權利。