請用此 Handle URI 來引用此文件:
http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/9912
標題: | 無線感知系統之天線設計 Sensor Network Antenna Design |
作者: | Tzung-Yu Wu 巫宗祐 |
指導教授: | 鄭士康(Shyh-Kang Jeng) |
關鍵字: | 無線感知系統,貼片天線,PIFA, sensor network,patch antenna,PIFA, |
出版年 : | 2008 |
學位: | 碩士 |
摘要: | 無線感知網路(wireless sensor network)是近年來相當熱門的技術,隨著技術發展,漸漸出現一些具有商業價值的應用,相信不久的將來,生活周遭會充滿應用這項技術的產品。但是我們發現目前的天線設計是有問題的,由於感知節點內能應用的空間十分有限,我們將無法避免由電池或電路板所構成的金屬環境對天線造成影響。為了解決金屬環境的問題,文中先藉由簡單的無線通道計算和IEEE 802.15.4所制定之規格,決定不同室內環境下天線所需的增益值和頻率,再對於應用時天線下方的金屬環境,決定天線的設計目標。本研究提出一種適用於感知節點上的貼片天線設計,並且利用短路金屬柱達到縮小面積的目的,同時對於一般貼片天線頻寬不足的問題,我們利用寄生天線的方式增加頻寬。文末特別針對天線下方為金屬導體時,比較常用於小型通訊產品之印刷導置F天線與本研究之設計,實驗結果可發現,本文所提出之設計對於天線下方的金屬環境較為不敏感。 In recent years there has been an increasing focus on the technology of commercial products associated with the development of wireless sensor network. In the near future, we believe that wireless sensor network will be all around and incorporated into our daily life. But we find a problem with the antenna design of wireless sensor. The antenna suffers from the influence of metal environments, such as the battery. And we can’t abate the interference because of the limited space available in the sensor node. In this article, we use the standard suggested by IEEE 802.15.4 to decide the gain and frequency required for different indoor environment. We chose antennas suitable for the metal environment at the same time. In this thesis, we propose a patch type antenna with a shorting wall and a parasitic antenna. The shorting wall is to reduce the size of patch. The parasitic antenna is to increase the bandwidth. We also prepared an experiment to test the printed inverted F antenna and this work in the metal environment. The experimental results show that our antenna is less sensitive to the metal environment. |
URI: | http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/9912 |
全文授權: | 同意授權(全球公開) |
顯示於系所單位: | 電信工程學研究所 |
文件中的檔案:
檔案 | 大小 | 格式 | |
---|---|---|---|
ntu-97-1.pdf | 1.5 MB | Adobe PDF | 檢視/開啟 |
系統中的文件,除了特別指名其著作權條款之外,均受到著作權保護,並且保留所有的權利。