請用此 Handle URI 來引用此文件:
http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/30968
標題: | 具寬線性範圍頻率偵測器之低抖動資料時脈回復電路 A Low-Jitter Clock and Data Recovery Circuit with Wide-Linear-Range Frequency Detector |
作者: | Ming-Hwa Lee 李明華 |
指導教授: | 李泰成(Tai-Cheng Lee) |
關鍵字: | 資料時脈回復電路,相位偵測器, Clock and Data Recovery,Phase Detector, |
出版年 : | 2007 |
學位: | 碩士 |
摘要: | 近年來的序列通訊系統傳送速度已高達每秒十億位元等級,因此大量的頻寬需求使的傳輸材料漸漸從傳統的銅轉變為光纖。由於低成本的考量,10GBASE乙太網路無論是在LANs 或是WANs皆伴演著重要的角色。而在通訊系統之接收端,資料與時脈回復電路被用來產生與接收資料同步之時脈並且去除輸入隨機資料的抖動。傳統上如此高速之電路通常是以 GaAs MESFET或 Si bipolar製程來實現,然而近年來CMOS 相關製程被認為更加適合用來實現這些高速電路,因為它的低成本,低功率消耗跟高度的整合能力。
本論文提出一個應用於10GBASE-LX4 乙太網路之31.25 億位元資料時脈回復電路設計。此電路採用一個低抖動哈吉型相位偵測器來降低輸出時脈之抖動跟一個寬線性範圍之頻率偵測器來縮短系統的頻率鎖定時間。由於資料時脈回復電路之頻寬通常被規格限制的很小,同時限制了資料時脈回復電路的鎖定範圍。如果沒有頻率取得迴路,資料時脈回復電路將會需要額外的外給參考時脈。由於較佳的製程,電壓跟溫度變異容忍能力,數位相關器的技術被大量使用在資料時脈回復電路的頻率取得迴路上。而本次的設計提出一個改良式的頻率偵測器來增加頻率迴路的線性操作區間並縮短頻率鎖定所需之時間。除此之外,我們也提出一個低抖動的哈吉型相位偵測器來減低輸出時脈的抖動而不需要改變到迴路的頻寬。本晶片是以0.18-μm 1P6M CMOS製程實現,而它的面積為0.61 毫米 × 0.61 毫米。本次提出的資料時脈回復電路量測結果,時脈抖動的峰對峰值為70 ps而其方均根值為 8.3 ps。輸入資料為231-1 PRBS時,位元錯誤率的量測結果小於10-12。而供給電壓為一點八伏特時,電路消耗的功率為61毫瓦。 In recent years, the speed of serial communication has been increased to multi-gigabits per second. The large demand of bandwidth converts the transmission medium from copper wire to fiber gradually. For both local area networks (LANs) and wide area networks (WANs), 10GBASE Ethernet plays an important role because of the low cost. In the receiver side, clock and data recovery (CDR) circuits can be employed to generate the clocks synchronized with received data and remove the jitter of input random data. Traditionally, GaAs MESFET or Si bipolar technology is usually used for implementing such high speed circuits. However, CMOS technologies are now considered in these high-speed circuits because of the low cost, low power dissipation, and highly integrated capability. Designed for the applications of 10GBASE-LX4 Ethernet, a 3.125-Gb/s CDR is proposed to lower the output clock jitter and decrease the frequency acquisition time by employing a low-jitter Hodge phase detector and a wide-linear-range frequency detector. Due to the requirement of the small loop bandwidth of CDR, pull-in range is limited and CDR without frequency acquisition loops might need additional reference clocks. Digital quadricorrelator techniques are widely used for frequency acquisition loops because of the tolerance to process, voltage, and temperature variations. In this work, a modified frequency detector is proposed to widen linear range, which can decrease the frequency acquisition time. Besides, a low-jitter Hogge phase detector is also proposed to minimize output clock jitter with no need of loop bandwidth change. This chip is fabricated in a 0.18-μm 1P6M CMOS technology and occupies a chip area of 0.61 mm × 0.61 mm. The output jitter of this proposed CDR is measured 70 ps (peak-to-peak) and 8.3 ps (rms), and the measured bit-error rate (BER) is less than 10-12 for 231-1 PRBS. The power dissipation of core circuit is 61 mW from a single 1.8-V power supply. |
URI: | http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/30968 |
全文授權: | 有償授權 |
顯示於系所單位: | 電子工程學研究所 |
文件中的檔案:
檔案 | 大小 | 格式 | |
---|---|---|---|
ntu-96-1.pdf 目前未授權公開取用 | 2.21 MB | Adobe PDF |
系統中的文件,除了特別指名其著作權條款之外,均受到著作權保護,並且保留所有的權利。