請用此 Handle URI 來引用此文件:
http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/28687
標題: | 利用超臨界二氧化碳進行聚碸薄膜表面接枝之研究 Surface Grafting of Polysulfone Membrane Using Supercritical Carbon Dioxide |
作者: | Tsung-Chin Chen 陳宗勤 |
指導教授: | 陳延平 |
關鍵字: | 聚碸,超臨界二氧化碳,自由基接枝聚合,丙烯酸,甲基丙烯酸羥乙酯, polysulfone,acrylic acid,HEMA,grafting,SCCO2, |
出版年 : | 2007 |
學位: | 碩士 |
摘要: | 聚碸高分子薄膜(polysulfone membrane)是一種被廣泛使用的血液透析薄膜,然而PSf薄膜卻具有疏水性的表面,導致其生物相容性不佳,限制了PSf在血液透析中的應用。本實驗利用超臨界二氧化碳(SCCO2)取代傳統有機溶劑,以2,2’-azobisisobutyronitrile(AIBN)做為起始劑,利用自由基接枝聚合法將丙烯酸(AAc)及甲基丙烯酸羥乙酯(HEMA)等親水性單體接枝在PSf薄膜上,使疏水性表面改質成為親水性。
實驗中我們藉由調整反應溫度、操作壓力、反應時間及反應物濃度等操作參數來控制接枝的程度。接枝HEMA單體時,當反應溫度為80℃、壓力為17.5 MPa、AIBN及HEMA濃度分別為0.04 M及0.12 M,在反應時間5小時的操作條件下,可以得到最大的接枝重量百分比 36.0 wt%。而PSf薄膜的親水性可隨著接枝程度的增加而增加,表面接觸角可從原來的88.6o ± 1.1降至43.0o ± 2.4(n=10)。 然而在接枝AAc的系統中,當反應溫度為85℃、壓力為17.5 MPa、AIBN及AAc濃度分別為0.04 M及0.12 M,反應時間則僅需3小時,可以得到最大的接枝重量百分比 20.4 wt%。而其表面接觸角則可以從88.6o ± 1.1降至43.2o± 3.0(n=10)。 薄膜改質後可由Fourier transform infrared spectroscopy (FTIR)分析薄膜表面的化學性質,scanning electron microscopy(SEM)觀察表面型態上的改變,differential scanning calorimetry (DSC)分析熱性質的變化,以及X-ray Induced Photoelectron Spectroscop(XPS)分析表面蛋白質吸附的情形。由以上諸多分析實驗結果,可證明我們可以利用超臨界二氧化碳做為溶劑,成功的將HEMA及AAc接枝於PSf薄膜表面上,並能有效的將疏水性的薄膜表面改質成為親水性。 Polysulfone (PSf) is a widely used material in membrane for hemodialysis. However, the hydrophobic nature of PSf limit its application in hemodialysis. Graft acrylic acid (AAc) and 2-Hydroxyethyl methacrylate (HEMA) monomer onto PSf membrane by free-radical polymerization using supercritical carbon dioxide (SCCO2) as a solvent and swelling agent. The PSf membrane was first impregnated with the monomer and initiator AIBN with SCCO2, and the monomer molecules were grafted onto the PSf membrane at a higher temperature. By this method, the grafting level can be controlled by temperature, pressure, reaction time, and concentration of reaction agents. When temperature is 80℃, pressure is 17.5 MPa, the concentration of HEMA and AIBN are 0.12M and 0.04M. At reaction time 5h, the grafting percentage of PSf-g-HEMA is 36.0 wt%. Further, at the optimal condition of grafting AAc, the grafting percentage is 20.4 wt%. The modified surfaces were characterized by Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), differential scanning calorimetry (DSC), contact angle and X-ray induced photoelectron spectroscop (XPS). The hydrophilicity of the membranes is increased after grafting. The contact angle of modified PSf membranes are reduced from 88.6o ± 1.1 to 43.0o ± 2.4 (n=10). |
URI: | http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/28687 |
全文授權: | 有償授權 |
顯示於系所單位: | 化學工程學系 |
文件中的檔案:
檔案 | 大小 | 格式 | |
---|---|---|---|
ntu-96-1.pdf 目前未授權公開取用 | 2.23 MB | Adobe PDF |
系統中的文件,除了特別指名其著作權條款之外,均受到著作權保護,並且保留所有的權利。