請用此 Handle URI 來引用此文件:
http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/21198
完整後設資料紀錄
DC 欄位 | 值 | 語言 |
---|---|---|
dc.contributor.advisor | 趙修武 | |
dc.contributor.author | Yen-Cheng Chiang | en |
dc.contributor.author | 江衍成 | zh_TW |
dc.date.accessioned | 2021-06-08T03:28:32Z | - |
dc.date.copyright | 2019-08-20 | |
dc.date.issued | 2019 | |
dc.date.submitted | 2019-08-19 | |
dc.identifier.citation | [1] Chamorro, L. P., & Porté-Agel, F. (2009). A Wind-Tunnel Investigation of Wind-Turbine Wakes: Boundary-Layer Turbulence Effects. Boundary-Layer Meteorology, Vol.132, No.1, pp.129-149.
[2] Barthelmie, R. J., Pryor, S. C., Frandsen, S. T., Hansen, K. S., Schepers, J. G., Rados, K., ... & Neckelmann, S. (2010). Quantifying the Impact of Wind Turbine Wakes on Power Output at Offshore Wind Farms. Journal of Atmospheric and Oceanic Technology, Vol.27, No.8, pp.1302-1317. [3] Lee, K. C. (2018). A Wake Model for Wind Turbine Power Prediction. Master Thesis. National Taiwan University. [4] Porté-Agel, F., Wu, Y. T., & Chen, C. H. (2013). A Numerical Study of the Effects of Wind Direction on Turbine Wakes and Power Losses in a Large Wind Farm. Energies, Vol.6, No.10, pp. 5297-5313. [5] Gebraad, P. M., Teeuwisse, F. W., Van Wingerden, J. W., Fleming, P. A., Ruben, S. D., Marden, J. R., & Pao, L. Y. (2016). Wind Plant Power Optimization through Yaw Control Using a Parametric Model for Wake Effects—a CFD Simulation Study. Wind Energy, Vol.19, No.1, pp.95-114. [6] Fleming, P., Annoni, J., Scholbrock, A., Quon, E., Dana, S., Schreck, S., ... & Schlipf, D. (2017, May). Full-Scale Field Test of Wake Steering. Journal of Physics: Conference Series, Vol.854, No.1. [7] van Dijk, M. T., van Wingerden, J. W., Ashuri, T., Li, Y., & Rotea, M. A. (2016, September). Yaw-Misalignment and Its Impact on Wind Turbine Loads and Wind Farm Power Output. Journal of Physics: Conference Series, Vol.753, No. 6. [8] Kim, M. G., & Dalhoff, P. H. (2014). Yaw Systems for Wind Turbines–Overview of Concepts, Current Challenges and Design Methods. Journal of Physics: Conference Series, Vol.524, No.1. [9] Kragh, K. A., & Hansen, M. H. (2015). Potential of Power Gain with Improved Yaw Alignment. Wind Energy, Vol.18, No.6, pp.979-989. [10] Damiani, R., Dana, S., Annoni, J., Fleming, P., Roadman, J., Dam, J. V., & Dykes, K. (2018). Assessment of Wind Turbine Component Loads Under Yaw-Offset Conditions. Wind Energy Science, Vol.3, No.1, pp.173-189. [11] Jiang, Y. C., Wong, S. K., & Chau, S. W., (2018). Wind Turbine Flow Modeling in a Wake Deflection Arrangement. Advanced Maritime Engineering Conference, Korea. [12] Neill, S. P., & Hashemi, M. R. (2018). Fundamentals of Ocean Renewable Energy: Generating Electricity from the Sea. Academic Press. [13] So̸rensen, J. N., & Shen, W. Z. (2002). Numerical Modeling of Wind Turbine Wakes. Journal of fluids engineering, Vol.124, No.2, pp.393-399. [14] Chau, S.W., Jiang, Y. C., & Tan, C. L. (2018). Power Prediction of a Linearly Aligned Wind Turbine Array via an Actuator Disk Model. Conference of Taiwan Wind Energy Association, Taiwan. [15] Wu, Y. K., Lee, C. Y., & Shu, G. H. (2011). Taiwan's First Large-Scale Offshore Wind Farm Connection—A Real Project Case Study with a Comparison of Wind Turbine. IEEE Transactions on Industry Applications, Vol.47, No.3, pp.1461-1469. [16] Johansson, S. H., Davidson, L., & Olsson, E. (1993). Numerical Simulation of Vortex Shedding Past Triangular Cylinders at High Reynolds Number Using a k‐ε Turbulence Model. International Journal for Numerical Methods in Fluids, Vol.16, No.10, pp.859-878. [17] Argyropoulos, C. D., & Markatos, N. C. (2015). Recent Advances on the Numerical Modelling of Turbulent Flows. Applied Mathematical Modelling, Vol.39, No.2, pp.693-732. [18] Mikkelsen, R. F., & Sørensen, J. N. (2004). Actuator Disc Methods Applied to Wind Turbines. Doctoral Dissertation. Technical University of Denmark. [19] Lee, K. C., & Chau, S. W. (2018). Wind Farm Wake Modeling Using an Actuator Disk Model. Advanced Maritime Engineering Conference, Korea. [20] Crasto, G., Gravdahl, A. R., Castellani, F., & Piccioni, E. (2012). Wake Modeling with the Actuator Disc Concept. Energy Procedia, Vol.24, pp.385-392. [21] Chau, S. W., & Hsu, K. L. (2011). Modeling Steady Axis-Symmetric Thermal Plasma Flow of Air by a Parallelized Magneto-Hydrodynamic Flow Solver. Computers & Fluids, Vol.45, No.1, pp.109-115. [22] Castellani, F., & Vignaroli, A. (2013). An Application of the Actuator Disc Model for Wind Turbine Wakes Calculations. Applied Energy, Vol.101, pp.432-440. [23] Stone, H. L. (1968). Iterative Solution of Implicit Approximations of Multidimensional Partial Differential Equations. SIAM Journal on Numerical Analysis, Vol.5, No.3, pp.530-558. [24] Ferziger, J. H., & Peric, M. (2012). Computational Methods for Fluid Dynamics. Springer Science & Business Media. [25] Chau, S. W. (1997). Numerical Investigation of Free-Stream Rudder Characteristics Using a Multi-Block Finite Volume Method. Doctoral Dissertation. University of Hamburg. [26] Hsu, S. A., Meindl, E. A., & Gilhousen, D. B. (1994). Determining the Power-Law Wind-Profile Exponent Under Near-Neutral Stability Conditions at Sea. Journal of Applied Meteorology, Vol.33, No.6, pp.757-765. [27] Richardson, L. F. (1911). The Approximate Arithmetical Solution by Finite Differences of Physical Problems Involving Differential Equations, with an Application to the Stresses in a Masonry Dam. Phil. Trans. R. Soc. A, Vol.210, No.459-470, pp.307-357. [28] Wu, Y. T., & Porté-Agel, F. (2015). Modeling Turbine Wakes and Power Losses within a Wind Farm Using LES: An Application to the Horns Rev Offshore Wind Farm. Renewable Energy, Vol.75, pp.945-955. [29] Huang, G. H. (2018) Study on Performance Factor of Wind Turbines and Wind Farms. Master Thesis. National Taiwan University. [30] Jamil, M., Parsa, S., & Majidi, M. (1995). Wind Power Statistics and an Evaluation of Wind Energy Density. Renewable Energy, Vol.6, No.5-6, pp.623-628. | |
dc.identifier.uri | http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/21198 | - |
dc.description.abstract | 本研究以台灣三處陸域風場的長期風況量測值為基礎,統計風向、風速和機率的關係,藉由統計結果定義特徵風況,並使用風機致動盤模型程式WIFA3D求解三維穩態連續方程式、動量方程式及k-ε 紊流模型,獲得風場中特徵風況下的功率輸出。接著,使用特徵風況計算三處風場在長期風況下的功率輸出與容量因子,並與實測值比較驗證。由於風場實測資料中缺乏獨立測風塔的資料,僅有各風機的風速與風向實測值,因此在每段時間間隔中以各風機的實測風速與風向值決定實際入流風況進行功率預測。計算結果顯示,本研究預測方法的風場容量因子計算值在前兩座風場中與實測值大致相符,唯第三座風場因實測功率曲線明顯偏離設計功率曲線,因此風場容量因子計算值與實測值差異較大。為確認本研究預測方法的合理性,使用第三座風場的實測功率曲線作為修正風機功率曲線的依據,發現修正後的容量因子預測值與實測值相近,說明本研究提出的方法在預測正常操作狀態下的風場功率具有一定的精確度。 | zh_TW |
dc.description.abstract | This study predicts the power characteristics of three onshore Taiwanese wind farms based on the wind direction distribution and wind data from long-term meteorological measurements in those wind farms, where typical wind condition is then defined from the statistical result of measurement. To calculate the power output under typical wind condition in the wind farm, a three-dimensional flow field is described by the steady continuity and momentum equation coupled with k-ε turbulence model, which is solved by an actuator disk model code, WIFA3D. The power output of long-term SCADA data in the wind farm is then predicted with a method proposed in this study and compares with the measured wind farm power output. In the proposed approach, inflow condition for a specific time span is determined by the measured data of wind turbines according to the incoming wind direction. The predicted result shows that the averaged capacity factor of the first two wind farms via the proposed method is close to the measurement while substantial error occurs in the third wind farm since the measured wind turbine power deviates considerably from the design power curve. For confirming the accuracy of the prediction method, the wind turbine power curve in the third wind farm is then corrected according to the measured power characteristics. The corrected capacity factor is in good agreement with the corresponding measurement, which suggests that the proposed approach has a satisfactory accuracy in predicting wind farm power behaviors. | en |
dc.description.provenance | Made available in DSpace on 2021-06-08T03:28:32Z (GMT). No. of bitstreams: 1 ntu-108-R06525016-1.pdf: 5412590 bytes, checksum: ca6505911592c9f8bb8e9f132d5b1ff1 (MD5) Previous issue date: 2019 | en |
dc.description.tableofcontents | Nomenclature I
List of Figures IV List of Tables VII Chapter 1 Introduction 1 Chapter 2 Numerical Model 3 2.1 Governing Equation 3 2.2 Actuator Disk Model 5 2.3 Body Force Computation 6 2.4 Distribution of Body Force 9 2.5 Numerical Method 11 2.6 Computational Domain 13 2.7 Boundary Condition 14 2.8 Mesh Arrangement and Grid Dependency 15 2.9 Validation 18 Chapter 3 Power Prediction 20 3.1 Statistical Analysis of SCADA Data 20 3.2 Power Prediction Method 21 Chapter 4 Numerical Results 25 4.1 Wind Farm A 25 4.2 Wind Farm B 33 4.3 Wind Farm C 41 4.4 A Further Discussion 51 Chapter 5 Conclusion 58 Reference 59 | |
dc.language.iso | en | |
dc.title | 以致動盤模型預測風場功率 | zh_TW |
dc.title | Wind Farm Power Prediction via Actuator Disk Model | en |
dc.type | Thesis | |
dc.date.schoolyear | 107-2 | |
dc.description.degree | 碩士 | |
dc.contributor.oralexamcommittee | 鍾年勉,蔡進發,吳毓庭,林宗岳 | |
dc.subject.keyword | 容量因子,致動盤模型,風場,功率曲線, | zh_TW |
dc.subject.keyword | Capacity Factor,Actuator Disk Model,Wind Farm,Power Curve, | en |
dc.relation.page | 61 | |
dc.identifier.doi | 10.6342/NTU201903523 | |
dc.rights.note | 未授權 | |
dc.date.accepted | 2019-08-19 | |
dc.contributor.author-college | 工學院 | zh_TW |
dc.contributor.author-dept | 工程科學及海洋工程學研究所 | zh_TW |
顯示於系所單位: | 工程科學及海洋工程學系 |
文件中的檔案:
檔案 | 大小 | 格式 | |
---|---|---|---|
ntu-108-1.pdf 目前未授權公開取用 | 5.29 MB | Adobe PDF |
系統中的文件,除了特別指名其著作權條款之外,均受到著作權保護,並且保留所有的權利。