請用此 Handle URI 來引用此文件:
http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/17161
完整後設資料紀錄
DC 欄位 | 值 | 語言 |
---|---|---|
dc.contributor.advisor | 李雨 | |
dc.contributor.author | Yen-Ming Chen | en |
dc.contributor.author | 陳妍名 | zh_TW |
dc.date.accessioned | 2021-06-07T23:59:02Z | - |
dc.date.copyright | 2013-08-20 | |
dc.date.issued | 2012 | |
dc.date.submitted | 2013-08-16 | |
dc.identifier.citation | Anoop, K., Sadr, R., Yu, J., Kang, S., Jeon, S. and Banerjee, D. 2012. Experimental study of forced convective heat transfer of nanofluids in a microchannel. International Communications in Heat and Mass Transfer, 39 pp. 1325-1330.
Byrne, M., Hart, R. and Da Silva, A. 2012. Experimental thermal–hydraulic evaluation of CuO nanofluids in microchannels at various concentrations with and without suspension enhancers. International Journal of Heat and Mass Transfer, 55 pp. 2684-2691. Choi, S. and Eastman, J. 1995. Enhancing thermal conductivity of fluids with nanoparticles. Dalkilic, A., Kayaci, N., Celen, A., Tabatabaei, M., Yildiz, O., Daungthongsuk, W. and Wongwises, S. 2012. Forced Convective Heat Transfer of Nanofluids - A Review of the Recent Literature. Current Nanoscience, 8 pp. 949-969. Ding, Y., Alias, H., Wen, D. and Williams, R. 2006. Heat transfer of aqueous suspensions of carbon nanotubes (CNT nanofluids). International Journal of Heat and Mass Transfer, 49 pp. 240-250. Hart, R. and Da Silva, A. 2011. Experimental thermal–hydraulic evaluation of constructal microfluidic structures under fully constrained conditions. International Journal of Heat and Mass Transfer, 54 pp. 3661-3671. Jung, J. and Kwak, H. 2008. Fluid flow and heat transfer in microchannels with rectangular cross section.Heat Mass Transfer, 44 pp. 1041-1049. Jung, J. and Yoo, J. 2009. Thermal conductivity enhancement of nanofluids in conjunction with electrical double layer (EDL). International Journal of Heat and Mass Transfer, 52 pp. 525-528. Jung, J., Oh, H. and Kwak, H. 2009. Forced convective heat transfer of nanofluids in microchannels.International Journal of Heat and Mass Transfer, 52 pp. 466-472. Kays, W. and Crawford, M. 1980. Convective heat and mass transfer. New York: McGraw-Hill. Keblinski, P., Phillpot, S., Choi, S. and Eastman, J. 2002. Mechanisms of heat flow in suspensions of nano-sized particles (nanofluids). International Journal of Heat and Mass Transfer, 45 pp. 855-863. Kleinstreuer, C. and Feng, Y. 2011. Experimental and theoretical studies of nanofluid thermal conductivity enhancement: a review. Nanoscale Research Letters, 6. Li, J. and Kleinstreuer, C. 2008. Thermal performance of nanofluid flow in microchannels. International Journal of Heat and Fluid Flow, 29 pp. 1221-1232. Murshed, S., Leong, K. and Yang, C. 2008. Thermophysical and electrokinetic properties of nanofluids – A critical review. Applied Thermal Engineering, 28 pp. 2109-2125. O'hanley, H., Buongiorno, J., Mckrell, T. and Hu, L. 2012. Measurement and Model Validation of Nanofluid Specific Heat Capacity with Differential Scanning Calorimetry. Advances in Mechanical Engineering, 2012. Pak, B. and Cho, Y. 1998. Hydrodynamic and heat transfer study of dispersed fluid with submicron metallic oxide particles. Experimental Heat Transfer, 11 pp. 151-170. Prasher, R., Song, D., Wang, J. and Phelan, P. 2006. Measurements of nanofluid viscosity and its implications for thermal applications, Applied Physics Letters, 89, 133108. Singh, P., Harikrishna, P., Sundararajan, T. and Das, S. 2011. Experimental and numerical investigation into the heat transfer study of nanofluids in microchannel. Journal of Heat Transfer, 133 p. 121701. Wang, X. and Mujumdar, A. 2007. Heat transfer characteristics of nanofluids: a review. International Journal of Thermal Sciences, 46 pp. 1-19. Wang, X., Xu, X. and Choi, S. 1999. Thermal Conductivity of Nanoparticle–Fluid Mixture. Journal of Thermophysics and Heat Transfer, 13 (4). Wen, D. and Ding, Y. 2006. Natural Convective Heat Transfer of Suspensions of Titanium Dioxide Nanoparticles (Nanofluids). IEEE Transactions on Nanotechnology, 5 (3), pp. 220-227. White, F. 1991. Viscous fluid flow. New York: McGraw-Hill. Wu, W., Liu, S., Hong, H. and Chen, S. 2012. Stability Analysis of Water-Based Nanofluids Prepared by Using Supersonic Dispersion Method. Advanced Materials Researsh, 383-390 pp. 6174-6180. Yu, W. and Choi, S.U.S. 2003. The role of interfacial layers in the enhanced thermal conductivity of nanofluids: A renovated Maxwell model, Journal of Nanoparticle Reasearch, 5, pp. 167-171. 傅柏欽, 2012, “結構與轉移函數對類神經網路運用於輻射測溫法在鋼材上之影 響”, 國立成功大學機械工程研究所碩士論文 劉文恭, 2007, “方形容器內氧化鋁-水奈米流體之自然對流熱傳之實驗研究”, 國立成功大學機械工程研究所碩士論文 | |
dc.identifier.uri | http://tdr.lib.ntu.edu.tw/jspui/handle/123456789/17161 | - |
dc.description.abstract | 奈米流體為液體溶液中懸浮有奈米顆粒的流體,其在熱傳導係數的增益方面多數文獻皆有明顯正面效應,其於傳統的強制對流實驗也有相當不錯之結果,但也有學者研究指出添加奈米顆粒對於熱對流係數有損無增的情形發生,而在自然對流實驗方面,許多研究都指出奈米液體的熱傳率相對於基底溶液有增有減,因而對奈米流體的力學與熱傳機制更添神秘面紗。多數研究認為奈米溶液在一定範圍體積分率內,其熱傳效果隨著濃度提升而增加,另外使用粒子之半徑越小越好,但這大多屬於理論分析之結論,實驗上仍有許多研究空間。本文擬以實驗方法在微流道內進行實驗,以增進了解奈米流體在微流系統中的應用。
本實驗利用微機電製程,製造出高寬為 50 x 50 um2、100 x 100 um2、及 100 x 1000 um2,長度皆為 17.5 mm 之微流道,以研究在不同雷諾數(Re = 0.6~18)、不同加熱功率與不同奈米溶液濃度(Phi = 0%, 0.6%, 1.2%, 1.8%)下的熱傳效果。微流道以PDMS 建置在一矽晶圓加熱基板上,在流道兩旁鋪有加熱電極,流道底部則建有五組測溫電極,以量測流道底壁溫度,另流道進出口皆有熱偶感溫線量測液溫。 實驗結果發現此裝置近似於等壁溫加熱, 使用粒子平均半徑為 19.7~101.1 nm 之二氧化鈦奈米溶液,其整體微流道系統熱對流係數會隨著雷諾數增加而提高,其濃度與熱對流係數之間無規律性。而就提高施加功率來說,整體系統的熱對流係數影響不大。 | zh_TW |
dc.description.abstract | Nanofluid is a liquid suspended with nano particles. According to the literature, the heat conductivity of nanofluid is increased significantly in comparing with their
base fluid. Forced convection is also enhanced for most of the reports, but there is a considerable amount of literature indicates that the heat transfer cannot be enhanced by using nanofluids in natural convection. It is general reported that the heat transfer enhancement is increased as the concentration of the particle increases and as the size of the particles decreases when the volume fraction of the particles is within certain range. The present study aims to study experimentally the convective heat transfer of nanofluids in micro channels. Micro channels with length 17.5 mm and cross sections 50 um x 50 um, 100 um x 100 um and 100 um x 1000 um were fabricated on silicon substrate using MEMS techniques. The top and the side walls were moulded with PDMS with two cylindrical reservoirs on both ends of the channels. Two heating electrodes were fabricated on the bottom walls of the channel for temperature measurement. The inlet and outlet fluid temperature were also measured using thermocouples. According to the experiment, the thermal boundary condition for the present micro device can be approximated as constant temperature for the bottom wall with the rest walls insulated. De-ionized water (the base fluid) and nanofluids (de-ionized water suspended with 0.6%, 1.2% and 1.8% nano sized TiO2 particles) were employed for the experiments. It was found that the heat transfer coefficient of the system increases linearly with Reynolds number for all the cases, but the heat transfer IV enhancement associated with nanofluids was not clearly observed. The heat transfer coefficient is essentially independent of the power input. | en |
dc.description.provenance | Made available in DSpace on 2021-06-07T23:59:02Z (GMT). No. of bitstreams: 1 ntu-101-R00543065-1.pdf: 1376304 bytes, checksum: 5c40b517849fa60b141ad2e553df0f02 (MD5) Previous issue date: 2012 | en |
dc.description.tableofcontents | 致謝 ………………………………………………………………………………… I
摘要 ………………………………………………………………………………… II Abstract …………………………………………………………………… III 目錄 ………………………………………………………………………………… V 圖表目錄 ………………………………………………………………………… VI 第一章 緒論 ………………………………………………………………… 1 1-1 研究目的與動機 ………………………………………………… 1 1-2 文獻回顧 ……………………………………………………………… 2 1-3 本文架構 ……………………………………………………………… 8 第二章 實驗裝置 ………………………………………………………… 9 2-1 實驗裝置 ……………………………………………………………… 9 2-2 微流道之設計與製作 ………………………………………… 14 2-3 基底電極加熱、溫度感測之設計與製作 ……… 17 2-4 絕熱裝置 ……………………………………………………………… 20 2-5 實驗儀器 ……………………………………………………………… 21 2-6 溫度感測電極之校正 ………………………………………… 22 第三章 奈米液體之調配 …………………………………………… 23 第四章 實驗結果 ………………………………………………………… 26 4-1 溫度校正與實際量測 ………………………………………… 26 4-2 奈米溶液之溫度量測 ………………………………………… 28 4-3 整體微流道系統之熱對流係數 ……………………… 33 第五章 結論與未來展望 …………………………………………… 41 參考文獻與書目 …………………………………………………………… 42 | |
dc.language.iso | zh-TW | |
dc.title | 微流道內奈米流體強制熱對流之實驗研究 | zh_TW |
dc.title | Experiment on Forced Convection of Nanofluids in Micro Channel | en |
dc.type | Thesis | |
dc.date.schoolyear | 101-2 | |
dc.description.degree | 碩士 | |
dc.contributor.oralexamcommittee | 沈弘俊,楊政穎 | |
dc.subject.keyword | 奈米流體,強制熱對流實驗,微流道,二氧化鈦, | zh_TW |
dc.subject.keyword | nanofluids,forced convection experiments,micro channels,TiO2, | en |
dc.relation.page | 44 | |
dc.rights.note | 未授權 | |
dc.date.accepted | 2013-08-16 | |
dc.contributor.author-college | 工學院 | zh_TW |
dc.contributor.author-dept | 應用力學研究所 | zh_TW |
顯示於系所單位: | 應用力學研究所 |
文件中的檔案:
檔案 | 大小 | 格式 | |
---|---|---|---|
ntu-101-1.pdf 目前未授權公開取用 | 1.34 MB | Adobe PDF |
系統中的文件,除了特別指名其著作權條款之外,均受到著作權保護,並且保留所有的權利。